cab files to the hard drive, you would need to remove it from the laptop and put it in another pc as a slave drive and copy them there.
![microsoft windows 98 emulator microsoft windows 98 emulator](https://cdn.arstechnica.net/wp-content/uploads/2014/01/windows-3.1.png)
You also need to create the autoexec.bat.Īs far as copying the. You would create a new one to replace the current one using the instructions above. They also have info on getting a cd-rom working in Dos.Īs far as opening the config.sys file, you don't need to. They've been around for years and have good reliable stuff.
MICROSOFT WINDOWS 98 EMULATOR FOR FREE
You can get a Win 98 boot disk for free from. Make sure you keep the current ones.Īlso, what happened when you did Sys C:? If that worked, the laptop should have booted to a C:\> without the floppy.ĭon't like the look of that website at all.
![microsoft windows 98 emulator microsoft windows 98 emulator](https://img.itch.zone/aW1nLzM3MTc2OTYucG5n/original/%2FoSCGC.png)
You would then copy the current ones off the floppy and replace them with the ones you made. You don't need to retype them, you can just copy and paste them into seperate notepad files and when you do that, go to File then Save as and in the box that opens change Save as type: to all files and then Save with the appropriate name. Its not just the Config.sys, but also Autoexec.bat that I suggested you try on the boot floppy. cab files to the hard drive and run setup from there.ĭid you try any of that? Its important you give me the info I'm looking for so that I can help. Not sure if your cd drive will become available then. If you boot from the floppy, assuming this hard drive is partitioned and formatted, you can run the command SYS C. These will only be hard drive letters, so the next available letter should be the cd drive.Ī little research shows that this was a common problem with that particular laptop.
![microsoft windows 98 emulator microsoft windows 98 emulator](http://www.emulators.com/images/GemPro_MacII_MacOS_Logo.gif)
I think the pertinent command here is LH C:\MSCDEX /D:TOSCD001 /M:10. If you do edit those two files, you would of course leave out the number preceding each line.Ĭan you tell us where you got this boot disk? What does it contain? If it contains FDisk, from the A:\> prompt run FDisk /status to see how the drive letters are assigned. Perhaps if you edit the ones on the floppy to contain those commands it might work. This webpage from Toshiba describes the Config.sys and Autoexec.bat files you would need to run that laptop.